Stampin’ Up!’s Magical Meadow Makes Stamping Simple

I choose to use a Basic White for my primary color with silver accents.
Here are the steps I used to assemble this elegant card.

1. Cut the cards layers.
2. Once my silver layer was cut, I die cut the tag out of  the center of the layer.
3. Brush the silver tag and Basic White scraps with the Embossing Buddy.
4. Using VersaMark Ink, stamp the sentiment on the silver tag and both leaf images (x2)
   on Basic White scrap.
5. Sprinkle the stamped sentiment with white embossing powder and the stamped leaf images
   with silver embossing powder. Tap off powder. Remove any unwanted remaining powder
   with a stiff bristled brush and heat set until images are a glossy.
6. Position and secure the coordinating dies around the stamped leaf images and run through SCEM.
7. Insert the Basic White mat into the Snowflake Sky Embossing Folder. Run through SCEM.
8. Adhere the embossed Basic White mat to the Silver mat. Adhere compiled mat to
   Basic White card base.
9. Arrange 2 large leaf die cuts and 1 small leaf die cut behind the label in the lower right corner.
   Adhere to back of label. 
10. Fold a piece of Silver & White Sheer Ribbon in half and thread the looped end through the
    center hole at the top of the label until half way through. Thread the cut ends through the loop
    and tighten to secure to label.
11. Add dimensionals to label and on back of die cut images.
    Adhere toward the bottom of the Basic White mat.
12. Cut the ends of the ribbon to desired length and embellish with 3 silver Festive Pearls.